Wiring Details - Tokyo Hy-Power HL-350VDX User Manual

*Wiring Details for REMOTE TERMINAL (remote controller connection jack) are
as follows:
When viewed
from the outside
of the rear panel•¨
Terminal No.
‡ @
‡ A
‡ B
‡ C
‡ D
‡ E
‡ F POWER SW
‡ G
Noun
RX SW This is connected to the switch of RX pre-amp.
When 13.8VDC is applied, the RX pre-amp will
be turned ON.
VCC This is connected to the + wire of the power
supply cable.
This pin always supplies 13VDC.
HI/LO SW When LO POWER position is selected, this pin
will supply 13VDC.
WARNING When WARNING Lamp is turned ON, this pin
will supply the voltage for lighting LED.
TX When the transmission is being made, this pin
supplies 13VDC (50mA max.).
GND This is a grounding pin.
This is connected to POWER SWITCH.
When 13.8VDC is applied here, POWER will
be turned ON.
NC This pin is not connected to anywhere.
Connection Details
8
(Don't connect
ACC CONNECTOR here!)