Unpacking; Introduction; Customer Support; Safety Precautions - American DJ Orbitron User Instructions

Orbitron™
General Instructions:
To optimize the performance of this product,
please read these operating instructions carefully to familiarize your-
self with the basic operations of this unit. These instructions contain
important safety information regarding the use and maintenance of
this unit. Please keep this manual with the unit, for future reference.

Unpacking:

Thank you for purchasing the Orbitron™ by American
DJ . Every Orbitron™ has been thoroughly tested and has been
®
shipped in perfect operating condition. Carefully check the shipping
carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your fi xture for any
damage and be sure all accessories necessary to operate the unit has
arrived intact. In the case damage has been found or parts are miss-
ing, please contact our toll free customer support number for further
instructions. Do not return this unit to your dealer without fi rst contact-
ing customer support.

Introduction:

The Orbitron™ is a unique intelligent fixture with a
rotating head unit. This unit may be operated in three modes; DMX-512,
Stand-Alone, or Master/Slave. The Orbitron™ comes with several build
in programs and is best used in multiples of four or more. This piece is
best used with a fog or haze machine to enhance the beam output. An
optional MINI/C black out controller may be purchased separately.

Customer Support:

American DJ
support line, to provide set up help and to answer any question should
you encounter problems during your set up or initial operation. You
may also visit us on the web at www.americandj.com for any com-
ments or suggestions. Service Hours are Monday through Friday 9:00
a.m. to 5:00 p.m. Pacifi c Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2610
E-mail: support@americandj.com
Warning!
To prevent or reduce the risk of electrical shock or fi re, do
not expose this unit to rain or moisture.
Caution! Caution! Caution!
There are no user serviceable parts inside this unit. Do not There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures
warranty. In the unlikely event your unit may require service please
contact your nearest American DJ
©American DJ® - www.americandj.com - Orbitron™ Instruction Manual Page 3
General Information
provides a toll free customer
®
dealer.
®
Orbitron™
Safety Issues: This unit may blow a fuse if the maximum allotted load
of 5 amps is reached. If the fuse needs replacement, always replace
the fuse with same exact type that was remove, unless otherwise
instructed by an authorized American DJ
different type fuse from that which is recommended may cause fire or
electric shock and will void the manufactures warranty.
• To reduce the risk of electrical shock or fi re, do not expose this unit
rain or moisture
• Do not spill water or other liquids into or on to your unit
• Do not attempt to operate this unit if the power cord has been
frayed or broken
• Do not attempt to remove or break off the ground prong from
the electrical cord. This prong is used to reduce the risk of
electrical shock and fi re in case of an internal short
• Disconnect from main power before making any type of connection
• Do not remove the cover under any conditions. There are no user
serviceable parts inside
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6" (15cm) between this device and a wall
• Do not attempt to operate this unit, if it becomes damaged
• This unit is intended for indoor use only, use of this product
outdoors voids all warranties
• During long periods of non-use, disconnect the unit's main power
• Always mount this unit in safe and stable matter Always mount this unit in safe and stable matter
• Power cords should be routed so they are not likely to be walked
on, pinched by items placed upon or against them.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 7 for cleaning details
• Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances
(including amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when: The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged. A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The fixture does not appear to operate normally or exhibits a
marked change in performance.
©American DJ® - www.americandj.com - Orbitron™ Instruction Manual Page 4

Safety Precautions

service technician. Use of a
®