Mounting; Dmx Traits - American DJ Orbitron User Instructions

Orbitron™
with halogen lamps. Never touch the new lamp with your bare
fingers.
2. Remove the thumb screw on the rear of the unit's head. This
screw hold the lamp socket cover in place.
3. Pull back the cover once the screw has been removed to access
the socket assembly.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble.
Lamp Cover
©American DJ® - www.americandj.com - Orbitron™ Instruction Manual Page 19
Fuse & Lamp Replacement
Lamp Socket
Assembly
Thumb Screw
Orbitron™
The Orbitron ships with a built-in rigging point and two large holes in
the base of the unit that are to be used for safety cables. The rigging
point is located on the bottom of the unit. This rigging point is secured
to the fi xture by two large Phillips screws. When the rigging point is
not to be used and when the fi xture is shipped from the manufacture,
the point is shipped inverted. When the fi xture is to be hung by truss
or other means, please use the rigging point and secure the fi xture
with safety cables. Always be sure to fi rmly secure the rigging point to
the unit. The Orbitron™ can be mounted to a wall or may hung from
truss.
Orbitron™
The chart below details the DMX traits in depth. The individual trait
can only be accessed by using an universal DMX controller. Note: The
gobo patterns can be found on the next page.
CHANNEL 1 CHANNEL 2
PAN TILT
255 255
255 335 degree 255
335 degree
00 0 degree 00 0 degree
00 00
©American DJ® - www.americandj.com - Orbitron™ Instruction Manual Page 20

Mounting

DMX Traits

ORBITRON
DMX TRAITS
CHANNEL 3 CHANNEL 4
BARREL LAMP
255
255
255
255
Speed Fast 60 RPM - 255
Barrel - CW
129-255
Speed Slow 1 RPM - 129
128
Stop - 128
Speed Slow 1 RPM - 127
01-127
Barrel - CCW
Speed Fast 60 RPM - 01
00 Stop 00
00 00
255
Lamp On
01
Lamp Off - 00