Stamina AVARI Recumbent Bike Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
STEP 8
Refer to the inset drawing and the illustration below to connect the TENSION KNOB(8) to the TENSION
CABLE(61) and assemble the UPRIGHT(2):
1. Set the TENSION KNOB(8) at position "8", so the CABLE END extends out of the METAL FITTING
as far as possible. Connect the CABLE END of the TENSION KNOB(8) to the HOOK on the end of the
TENSION CABLE(61).
2. Pull on the Cable of the TENSION KNOB(8) firmly so that enough cable is available to allow the METAL
FITTING to go through the slot in the top of the BRACKET.
3. Insert the METAL FITTING into the hole at the end of the slot in the BRACKET.
4. Adjust the TENSION KNOB(8) and verify that the HOOK moves when the TENSION KNOB(8) is adjusted.
5. Connect the EXTENSION WIRE(58) to the SENSOR WIRE(38). Connect the PULSE CONNECTING
WIRE(66) to the PULSE MIDDLE EXTENSION WIRE(57).
6. Insert the UPRIGHT(2) to the MAIN FRAME(1) and secure with BUTTON HEAD BOLTS(M8x1.25x15mm)
(55) and ARC WASHERS(M8)(56).
10
Metal Fitting
Cable End
1
Hook
Bracket
2
3