Body Or Hipmounting - Fisher M-Scope 1236-X2 Operating Manual

BODY or HIPMOUNTING

1. Disconnect the search coil cable from the
control housing and unwind all but the last 12
inches or so from the upper handle. Secure the
lower end of the cable with a Velcro® strap at
least 12 inches up from the coil.
2. Remove the control housing from the hand
grip by holding the grip with one hand and sliding
the housing toward you with the other.
3. Attach the belt loop to the control housing by
slipping it through the slots on the underside of
the control housing and pulling it toward the
control panel to lock it in place.
4. Reconnect the search coil cable to the control
housing.
5. The control housing can then be mounted on
your belt or on the optional Fisher Chest Harness.
It is especially important that the cable
connector be installed tightly (hand tightened
only) to prevent false signals during body-mount
use.
Note:
For belt mounting, left handers should wear the
housing on their right hip and right handers
should wear it on their left hip.
Once removed from the stem, the control box
can be hip or chest mounted leaving only the
stem and search coil to swing.
Figure 4a, 4b, 4c.
Hipmounting
7