Cleaning - Bunn My Café AP Installation & Operating Manual

SPRAYHEAD
1. Open the pod door with the "OPEN/CLOSE" switch.
2. Disconnect brewer from power source and allow to cool.
3. Remove 2 screws and top cover.
3. Slip one hand through pod door opening. With other hand turn thumbscrew counterclockwise. Remove
sprayhead assembly through front. Fig 8-1
4. Remove seal from sprayhead.
5. Check and clean the sprayhead. The sprayhead holes must always remain open. Fig 8-2. Clean all the holes
in the plastic sprayhead to remove any mineral deposits. Wash and rinse in sink.
6. When reassembling sprayhead, be sure to have seal installed with ridge facing up (A). Fig 8-3
FIG 8-1
FIG 8-2
SHOWN UPSIDEDOWN
FOR CLARITY
FIG 8-3

CLEANING

The use of a damp cloth rinsed in any mild, nonabra-
sive, liquid detergent is recommended for cleaning
all surfaces on Bunn-O-Matic equipment.
BIN /DRIPTRAY
1. Pull the driptray assembly straight towards you.
2. Pull the bin straight out and empty as required.
3. Seperate the parts as shown in Fig 8-4 and wash with
mild, nonabrasive, liquid detergent.
4. Assembly is in reverse order.
A
Page 8
FIG 8-4
41167.2 121710