Connecting Loads; Grounding The Generator - Titan TG 8500 Owner's Manual

P.O. Box 791
Travelers Rest, S.C. 29690
864-834-7212
Toll Free 1-888-828-8126
Replacement Parts 1-800-845-4141
MODEL TG 8500RC
GAS POWERED
ELECTRIC GENERATOR
Model
Voltage
Frequency
Continuous Watts
Surge Watts
DESCRIPTION
THE TITAN INDUSTRIAL INC. MODEL TG 8500RC is
a gas engine driven, revolving field, alternating current
(AC) generator designed to supply electrical power for
compatible electrical tools, motors, appliances, and light-
ing (see wattage reference guide on page 8 ).
The Model TG 8500RC operates at 120 volt and/or 240
volt, single phase, 60 Hz and will operate devices that
require up to 7200watts continuous, 8400 surge watts.
Figure #1 - Grounding Lug Block
TG 8500RC
120/240
60Hz
7200
8400

CONNECTING LOADS

Add up the Watts of all devices you connect to the TITAN
INDUSTRIAL GENERATOR at one time. Do not exceed
7200 Watts on TITAN INDUSTRIAL Generator Model TG
8500RC (see wattage reference guide).
The rated Watts of most electrical devices can be found
on its nameplate. The rated Watts of lights can be taken
from the light bulbs. In cases where only Volts and Amps
are shown on the nameplate, simply multiply Volts by
the Amps to get Watts (Volts X Amps = Watts).
Some electric motors require about three times the
rated Watts of power for start-up. This surge of power is
required for only a few seconds. Be sure to allow for this
high starting wattage when selecting electrical devices
to connect to the generator.
First, figure the watts needed to start the largest motor.
Add to that figure the running watts of all other con-
nected loads.
Please see the Wattage Reference Guide.
It provides an estimated approximation of running watts,
to help determine which devices to select to connect to
the generator.
CAUTION! Do not tamper with engine governed speed.
The TITAN INDUSTRIAL GENERATOR supplies correct
rated frequency and voltage when running at the proper
governed speed. Incorrect frequency and/or voltage
could damage connected electrical devices.

GROUNDING THE GENERATOR

It is required by The National Electrical Code to have the
frame and all external conductive parts of the generator
connected to an earth ground. Proper grounding also
satisfies most local electrical codes.
Connect a No. 12 AWG standard copper wire to the
Grounding Lug Block (See Figure 1). The grounding
lug can be found on the front of the contorl panel. Con-
nect the other end of the wire to an earth driven copper
or brass grounding rod (electrode).
CAUTION! Do not connect ground to a preexisting
ground rod, water pipe, or building frame.
Consult with a licensed electrician in your area because
local codes vary. Properly grounding the generator helps
prevent electrical shock if a ground fault condition exists
in the generator or in connected electrical devices. This
will also help to dissipate static electricity resulting from
ungrounded devices.
3