Table of Contents
Advertisement
10.4 Security Setting
Phone password is to be verified when upon entering security setting. The initial password for the newly purchased
handset is 0000. Please modify the password in time after your purchase of the handset.
10.4.1 Lock Phone
You can set the mode for Lock Phone. When the handset is locked up, you have to input the password for unlock.
10.4.2 PIN Set
When this function is set On, you are required to input PIN code of the R-UIM card for unlock.
10.4.3 Lock UIM to Phone
When this function is set On, the handset can only use the R-UIM card in it. If you want to change another new
R-UIM card, you will be required to input the code for unlock, firstly.
Note: To activate Lock UIM to Phone, you will be required to set Lock Code.
10.4.4 Change Password
1
Input the old password;
2
Input a new password;
3
Input the new password again;
4
Select [OK].
Note: If your handset supports R-UIM card, please refer to the following content, while if not you can
overleap this section.
10.4.5 Change PIN
1
Input the old R-UIM code;
2
Input a new R-UIM code;
3
Input a new R-UIM code again;
4
Select [OK].
Note: If you make mistake to input the PIN for three times, the R-UIM will be locked, then you need a PUK
for unlock. PIN may be provided with R-UIM card, but if not you can contact with the network service
provider. The defaulted is 1234.
Handset User Manual
38
http://www.zte.com.cn
Advertisement
Table of Contents
