Power Over Ethernet (Poe); Network Deployment - Vivotek FD8362 Quick Installation Manual

4

Network Deployment

General Connection (without PoE)
1. Connect RJ45 Ethernet cable to a switch.
Use a Category 5 Cross Cable when your
network camera is directly connected to PC.

Power over Ethernet (PoE)

When using a PoE-enabled switch
The Network Camera is PoE-compliant, allowing transmission of power and data via a single Eth-
ernet cable. Follow the below illustration to connect the Network Camera to a PoE-enabled switch
via Ethernet cable.
1. The DC power adaptor, if used, should
comply with: O/P: 12V DC, 1.5A min.,
L.P.S. certified.
2. Pin #3 & 4 AC 24V as alternate power are
for indoor use only
AC 24V±10%
Pin 4
Pin 3
Red
Pin 2
Pin 1
Black
2. Connect either the DC or AC cables from
the terminal block. The IO cables are user-
supplied.
PoE Switch
NOTE:
1. This equipment is only to be connected to PoE
networks without routing to outside plants.
2. For PoE input connections, use only UL listed I.T.E.
with PoE output.
EN - 9
NOTE:
Non-PoE Switch
DC 12V
Ethernet