Installation Table - Daikin DCS302C71 Operation Manual

INSTALLATION TABLE

When installing the equipment, mark the zone No. of each group and installation location in the below table.
Setting group No.
(Setting is not possible unless power is activated to
both the central remote controller and indoor unit.)
Operated by remote controller
1. Activate power to both the central remote controller
and indoor unit.
2. While in the normal mode, hold down the "
ton for a minimum of 4 seconds. The unified ON/
OFF controller will enter the FIELD SET MODE.
3. Select the MODE No. "
4. Use the " " button to select the group No. for
each group. (Group No. increases in the order of
1-00, 1-01 ... 1-15, 2-00, ... 8-15.)
5. Press " " to set the selected group No.
6. Press " " to return to the NORMAL MODE.
Zone No.
Group No. –00
Indoor unit
Quantity of units
Controlled by
Location
Zone No.
Group No. –00
Indoor unit
Quantity of units
Controlled by
Location
23
" with the " " button.
–01 –02 –03 –04
–01 –02 –03 –04
Operated by simplified remote controller
1. Activate power to both the central remote controller
and indoor unit.
2. Remove the upper part of the remote controller.
3. Press the
board. The controller will enter the FIELD SET
MODE.
" but-
4. Select the MODE No. "
TON and
5. Use the
BUTTON (set B) to select the group No. for each
group. (Group No. increases in the order of 1-00,
1-01 ... 1-15, 2-00, ... 8-15.)
6. Press
selected group No.
7. Press
NORMAL MODE.
–05 –06 –07 –08
–05 –06 –07 –08
BUTTON (field set) on the PC
" with the
BUTTON (temperature setting).
BUTTON (set A) and
BUTTON (set/cancel) to set the
BUTTON (field set) to return to the
–09 –10 –11 –12
–09 –10 –11 –12
BUT-
–13 –14 –15
–13 –14 –15
English