Summary of Contents for Hearth and Home Technologies Simplifyre SFE-35
Page 1
MODEL: SFE-35 BUILDER BOX INSTALLER / CONSUMER SAFETY INFORMATION PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING APPLIANCE WARNING IF THE INFORMATION IN THIS MANUAL IS NOT FOLOWED EXACTLY, AN ELECTRICAL SHOCK OR FIRE MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE Homeowner’s Installation &...
Congratulations! Congratulations on selecting a Simplifyre electric fireplace. The unit you have selected is designed to provide the utmost in safety, reliability and efficiency. As the owner of a new fireplace, you’ll want to read and carefully follow all of the instructions contained in this owner’s manual.
Important Instructions • When using electrical heaters, basic precautions should al- To prevent a possible fire, do not block air intakes or ex- ways be followed to reduce the risk of fire, electric shock and haust in any manner. • injury to persons, including the following: An heater has hot and arcing or sparking parts inside.
UNPACKING THE UNIT WARNING Do not use this fireplace if any part of it has been ELECTRICAL SPECIFICATIONS under water. Immediately call a qualified service technician to inspect and replace any of the electri- Voltage: 120 V AC, 60 Hz cal system if necessary.
OPERATING INSTRUCTIONS Ensure the appliance is connected to a properly grounded electrical outlet on a minimum 15 AMP circuit. If a new outlet is required, it should be installed according to applicable building codes. REMOTE CONTROL NOTE: if the fireplace does not respond to the hand held control see “Remote Control Initialization” below. This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules.
SERVICE INSTRUCTIONS WARNING SCREEN CLEANING Disconnect power at circuit breaker before attempting any maintenance or cleaning to reduce the risk of fire, electrical During shipment, installation, handling, etc., the shock or personal injury. screen surface may collect dust particles; these can be removed by lightly wiping with a clean, dry cloth.