Step 3 - Turn On The Thin Computer; Turning Off The Thin Computer; Removing The Battery; Connecting The Power Cable - Wyse Mobile Thin Computer User Manual

10
Chapter 3
Figure 3-2 Connecting the Power Cable

Step 3 - Turn On the Thin Computer

Raise and adjust the lid, and press the power on/off button for two seconds. When you
release the power on/off button, the power LED on the system indicators turns on.
After power-on, the thin computer initially goes through several boot sequence procedures
before the operating system loads. See "Setting Up Access to the Enterprise Servers" for
information about setting up your server environment. Additional information is available in
the thin computers' operating system documentation, Administrators Guide: Wyse
Series, Based on Microsoft

Turning Off the Thin Computer

Press the power on/off button for two seconds, or go to Start | Turn Off Computer and
click Turn Off.

Removing the Battery

With your thin computer turned off, slide the battery lock to unlock, and then slide and hold
the battery release latch to gently pull the battery out of the battery compartment.
Note
You can connect the power adapter at any time with the thin computer turned
either on or off.
® Windows
Caution
Before removing battery, turn off the thin computer and disconnect the power
adapter from the electrical outlet.
® XP Embedded.
® 9