HP EliteBook Revolve 810 G1 Maintenance And Service Manual page 70

g. Fan/heat sink assembly (see
h. System board (see
i. Hinge cover and hinge cap (see
Remove the display assembly:
1. Remove the two Phillips PM2.0×5.0 screws (1) that secure the display assembly to the top cover.
2. Slide the display assembly (2) away from the top cover and remove it.
Reverse this procedure to install the display assembly.
62 Chapter 4 Removal and replacement procedures
Fan/heat sink assembly on page
System board on page
Hinge cover on page
55)
57)
59)