Install The Vanity Cabinet - Kohler 2451 Installation And User Manual

Install the Vanity Cabinet

Leveller
1. Remove the drawer, door(s) and shelf from the vanity cabinets. Refer
to the appropriate section for more details.
2. Position the vanity cabinet against the finished wall.
3. Make sure that the vanity cabinet is level. If necessary, turn the
levellers on the bottom of each vanity leg to achieve this.
4. Mark the supply and drain locations on the inside of the vanity cabinet
back wall. Move the vanity cabinet away from the wall.
5. Using a suitable hole saw, cut out the marked supply and drain
locations on the vanity cabinet wall.
6. Position the vanity cabinet against the wall, aligning the supply and
drain locations with the cut-outs.
7. Drill two fixing holes through the mounting rail and into the finished
wall on each side of the vanity cabinet. Make sure the fixing holes are
spaced a minimum of 406 mm apart.
Finished Wall
Fixings in wall will
be dependant on wall
surface.
Vanity
Cabinet
7
Fixing
Screw
1067217-050
1067217-W2-B
Mounting
Rail