Starter Disable; Remote Panic - Silencer 7921P Owner's Manual

7921P Primary Feature Operation: (continued)
Override Operation
1. Enter the vehicle, the security systems will begin sounding at this point, and place the override
switch into the switch housing. Make sure that the switch button is in the OUT position.
2. Place the ignition key into the ignition switch and turn the ignition switch to the ON position.
3. Within 5 seconds of turning the ignition key ON, press the valet switch button IN until it locks.
4. The horn/siren will stop sounding.
5. The LED indicator will be solid red.
The security system is overridden and is now in the Valet Mode.
Valet Operation
1. Place the valet switch into the switch holder making sure that the switch button is in the OFF
position (switch button is out).
2. Turn the ignition key to the ON position.
3. Within 5 seconds of turning the ignition key ON, push IN the valet switch.
4. The LED will be on solid indicating that the security system is in the Valet Mode.
Note 1: If the valet switch is already in the ON position when you turn ON the ignition key, the valet
function will be bypassed. Turn OFF the ignition key, set the switch to the OFF position and try again.
Note 2: If you fail to push IN the valet switch within 5 seconds of turning ON the ignition key, the valet
function will be locked out. Turn OFF the ignition key, set the switch to the OFF position and try again.

Starter Disable

Your Silencer security system has a built-in starter interrupt relay that will break the connection between
your ignition key and the starter on your vehicle. To test this feature, repeat the following procedure:
1. Enter the vehicle and close all the entrances.
2. Press the LOCK button on the transmitter.
3. Turn the ignition key to the start position. The engine will not crank over.
4. Turn the ignition key to the OFF position and press the UNLOCK button on the transmitter.
5. Turn the ignition key back to the START position and the engine will crank over and start.

Remote Panic

The 7921P provides a remote panic function which allows the user to trigger the alarm by remote in the
case of an emergency.
Factory Supplied Keyless Entry Transmitter
1. Ignition key must be OFF.
2. Press the LOCK button 4 times.
3. The siren will begin to sound and the parking lights may begin to flash.
4. Press the UNLOCK button. The siren will stop sounding and if the parking lights are flashing they
will stop flashing.
Note: If the panic function is not turned off by the transmitter, the siren will continue to sound for 60
seconds and then turn off by itself.
Silencer Transmitter
1. The ignition key must be OFF.
2. Press and hold the
A. The siren or vehicle horn will begin sounding.
B. The parking lights may begin flashing.
C. Press the
Note: If the panic function is not turned off by the transmitter, the siren/horn will continue to sound for
60 seconds and then reset by itself.
6
Note: The removable valet switch can only be inserted into the
valet switch housing one way. Do not force the switch or bend the
switch terminals.
(security system is armed)
(security system is already disarmed)
button for 3 seconds and your Silencer system will respond in the following manner:
button to turn off the panic feature.