Advertisement
Quick Links
O W N E R ' S
M A N U A L
Models:
6904A, 7904A, 6908A,
6918A, 7919P and 7921P
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment.
Advertisement
Related Manuals for Silencer 6904A
Summary of Contents for Silencer 6904A
- Page 1 O W N E R ’ S M A N U A L Models: 6904A, 7904A, 6908A, 6918A, 7919P and 7921P This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 2 Remote Control Transmitters The Silencer security systems can operate from any one of the four transmitters shown here. Locate the transmitter that was supplied with your system and use the drawing as a ready reference while reading through the operating procedures.
- Page 3 B1.The LED indicator will be off. (Applies to 6908A, 6918A, 7919P and 7921P Only) B2.The LED indicator will be flashing very fast. (Applies to 6904A and 7904A Only) C. The parking lights will flash two times. (Applies to 6908A, 6918A, 7919P and 7921P Only, but is an...
- Page 4 Removable Valet/Override Switch Operation To provide a higher level of protection, all Silencer security systems are supplied with the patented removable valet switch system. The removable valet switch is used to override the security system in the event that the transmitters are lost or fail to operate and to put the security system in non-operational mode (valet) for vehicle servicing etc.
- Page 5 Note: If a protected entrance is left open, your Silencer security system will remain triggered for two more 60 second cycles then fully re-arm excluding the door input trigger. (Door input trigger is no longer functional) Closing the entrance will re-set the door input trigger within 7 seconds.
- Page 6 30 seconds. Option #3: Chirping Status Indicator (Applies to 6904A and 7904A Only) Installing option #3 will give the 6904A and 7904A security system an audible chirp to indicate when it is armed or disarmed. Option #4: Flashing Parking Light Status Indicator (An Option for 6904A and 7904A, Standard on 6908A,...
- Page 7 Option #6: Dual Zone Shock Sensor (Applies to 6908A, 6918A, 7919P, and 7921P Only) Installing option #6 will increase the level of security provided by your Silencer security system. Zone #1 of the dual zone shock sensor will detect lighter non-threatening disturbances that would normally set off most sensors and trigger the security system.
-
Page 8: Year Warranty
3 years from the date of sale to you, repair or replace said product or any part thereof, at the option of the Silencer or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the correct power requirements designated for the specific product.