3 channel security with keyless entry system (9 pages)
Summary of Contents for Silencer 6904A
Page 1
O W N E R ’ S M A N U A L Models: 6904A, 6908A, 6918A with Code Hopping Transmitters This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation.
Page 2
B. The LED indicator will begin to flash at a steady rate. C. The parking lights will flash one time. (Applies to 6908A and 6918A but is an option for 6904A) D. The starter is deactivated which prevents the engine from being started.
Page 3
The slide switch must be in the “on” position for the passive unlock feature to work. For total passive exiting and entry operations, you should have your security system programmed for “Automatic Passive Arming”. (Applies to 6904A and 6908A only) The security system is now disarmed!
Page 4
Removable Valet/Override Switch Operation To provide a higher level of protection, all Silencer ® security systems are supplied with the patented removable valet switch system. The removable valet switch is used to override the security system in the event that the transmitters are lost or fail to operate and to put the security system in non-operational mode (valet) for vehicle servicing etc.
Page 5
Note 2: (6904A Only) For remote panic to operate an optional status indicator must have been installed. Note 3: (6904A Only) For flashing lights to operate an additional module must have been installed.
Page 6
6918A only) Upgrade Options Available From Your Car Dealer (At an Additional Cost) The 6904A offers 5 upgrade options, and the 6908A and 6918A also offers 5 upgrade options as listed below. Option #1: Remote Power Door Lock/Unlock Control (All Models) Note: Your vehicle must have an electronic door locking system for this feature to operate.
Page 7
Option #6: Dual Zone Shock Sensor (Applies to 6908A and 6918A Only) Installing option #6 will increase the level of security provided by your Silencer security system. Zone #1 of the dual zone shock sensor will detect lighter non-threatening disturbances that would normally set off most sensors and trigger the security system.
Page 8
Silencer ® or its authorized agents, or where the warning seal on the product is broken or the power and/or plugs are detached from the unit.