HP Spectrext Maintenance And Service Manual page 53

3. Remove the Phillips PM screws securing each half of the front speaker (2).
4. Remove the speaker cables (3) that are routed on each side of the front area.
5. Remove the speakers (4).
Reverse this procedure to install the front speakers.
Before removing the rear speaker, follow these steps;
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
1. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
2. Remove the base enclosure (see
3. Disconnect the battery cable (see
4. Remove the system board (see
NOTE: The heat sink overlaps the rear speakers so the system board must be removed before
the rear speakers.
Remove the rear speakers
1. Disconnect the rear speaker cable from the USB/Audio board (1).
Base enclosure on page
Battery on page 31).
System board on page
29).
39).
Component replacement procedures 45