Safety Precautions - JVC TK-C685E Instructions Manual

SAFETY PRECAUTIONS

Information for Users on Disposal of Old
Equipment
[European Union]
This symbol indicates that the electrical and
electronic equipment should not be disposed as
general household waste at its end-of-life.
Instead, the product should be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment for proper
Attention:
treatment, recovery and recycling in accordance
with your national legislation.
This symbol
By disposing of this product correctly, you will
is only valid
help to conserve natural resources and will help
in the
prevent potential negative effects on the
European
environment and human health which could
Union.
otherwise be caused by inappropriate waste
handling of this product. For more information
about collection point and recycling of this
product, please contact your local municipal
office, your household waste disposal service or
the shop where you purchased the product.
Penalties may be applicable for incorrect disposal
of this waste, in accordance with national
legislation.
(Business users)
If you wish to dispose of this product, please visit
our web page www.jvc-europe.com to obtain
information about the take-back of the product.
[Other Countries outside the European Union]
If you wish to dispose of this product, please do
so in accordance with applicable national
legislation or other rules in your country for the
treatment of old electrical and electronic
equipment.
Mounting to a firm place
As the unit rotates at high speed, mount it on a firm place
with sufficient strength to support the vibration and weight
of the unit.
Mass: Approx. 1.9 kg (TK-C685E/TK-C686E)
Approx. 5.5 kg (TK-C685WPE/TK-C686WPE)
If the ceiling material (e.g., decorated plywood, plaster
board and bluster board) is not strong enough, apply
reinforcement materials such as veneer plywood.
(TK-C685E/TK-C686E)
If the strength is not sufficient, vibrations will cause fuzzy
images on the monitor screen. In the worst scenario, the
camera may even fall off and hit somebody, resulting in
serious accidents.
Mounting the camera correctly with the
designated mount brackets
Always use the designated mount brackets. Be sure to
connect the fall prevention wire and tighten the fixing
screws or nuts securely.
Using the correct power and voltage
The rated power of this product is AC24 V 50 Hz/60 Hz.
Supplying a power beyond the rated value may result in
failures and in the worst scenario, smoking and fire.
This unit is able to divert lightening conduction to itself and
the connecting cables to a certain extent but this is not 100
% guaranteed. For installation locations that are likely to
suffer lightening strikes, be sure to take appropriate
measures such as adding arrestor to the connecting cables.
Consult your dealer as special technique is required when
installing this product.
Ensure that the fixing screws or nuts are tightened securely,
otherwise, the unit may fall off.
Inspect the unit regularly.
Screws may be loosened due to vibration or deterioration of
the mounting section. Perform regular inspections for
loosened screws and check whether there is any danger of
the unit falling off.
Handle the camera unit carefully when installing
this product. Otherwise it may fall and result in
injuries.