Reference; Inserting A Memory Card; Troubleshooting - Mio Moov 200 Series User Manual

Reference

Inserting a memory card

CAUTION: Do not apply pressure to the centre of the memory card.
Hold the card (SD, SDHC, or MMC) by the edges and gently insert it into the slot with the label facing the front
of the Mio.
To remove a card, gently push the top edge of the card inwards to release it, and pull it out of the slot.

Troubleshooting

Note: If you encounter a problem you cannot solve, contact an authorized service center for assistance.
Problems
Power does not turn on when using battery
power.
Screen responds slowly.
Screen freezes.
Screen is hard to read.
Cannot establish a connection with a
computer.
30
Moov 200-Series
Solutions
The remaining battery power may be too low to run your Mio. Charge the
battery.
Make sure that your Mio is not running out of battery power. If the problem
still persists, reset your Mio.
Reset your Mio. (See "Shutdown and hardware reset" for information.)
Make sure that the backlight of the display is set to a high-enough brightness.
Make sure that your Mio and your computer are both turned on before trying
to establish a connection.
Make sure that the cable is securely plugged into the USB port on your
computer and on the Mio. Connect the USB cable directly to your
computer—do not run the cable through a USB hub.
Reset your Mio before connecting the cable. Always disconnect your Mio
before you restart your computer.
Moov 300-Series