Kidde i9060CA User Manual page 16

Maintenance
Safety Light
Model i9080CA
NOTE: If the safety light appears dim during regular testing,
replace both batteries immediately.
Use only the following 9 volt batteries for powering the
safet light:
Alkaline Type
These batteries can be purchased at your local retailer.
The safety light has a 6.3 V 250mA fuse lamp with an average life
of 50 hours. If the safety light fails to operate with a fresh
alkaline battery, then replace the lamp.
To replace the lamp, remove the alarm from the mounting
bracket by rotating the alarm in the direction of the "OFF" arrow
on the cover (Image 3D, and Alarm Tamper Resist Feature
section if this feature has been activated).
Open the battery door and remove both batteries from the unit.
Grip the lamp holder handle with your thumb and finger and pull
out the lamp holder assembly. Slide the old lamp out of the lamp
holder and replace it with a new lamp.
Replace with the correct lamp type: Vanco #FTB 6 which is
available at most radio/tv repair stores.
Reinstall the lamp holder. It will snap easily into the base. Put
working batteries back in the alarm and remount the alarm on its
mounting bracket.
CAUTION: Use only the lamp specified. Use of a different lamp
may have a detrimental effect on the smoke alarm or the safety
light operation.
NOTE: The safety light is not intended to satisfy the requirements
for approved illumination under various local codes. Very thick
and/or dense smoke may obscure the light.
15
Energizer 522
Duracell MN1604 or MX1604
Gold Peak 1604A
Panasonic 6AM6, 6AM-6, 6AM-6PI,
6AM6X and 6LR61 (GA)