Pedalboard Function Selection And Display - Gibson Firebird X Owner's Manual

4. Plug the supplied AC adapter plug into the matching jack on the left side of the
Pedalboard or Switchboard.
5. Raise the Bluetooth antennas on each pedal.
6. Turn on Firebird X by lifting up on the Gear Shift knob.
7. Push down on the Pedalboard pedal until you hear a click, and hold it down until the
display lights. The display will initially show Guitar Link Down and Bone (Pedal Power/Data
Connector) Link Down, but then will change to Guitar Up, and the display will show
Receiving config.... This confirms Firebird X and the Pedalboard are paired. After receiving
the configuration, the display will go to its default.
8. Press on the Switchboard's Upper Left footswitch. The Pedalboard display will turn on
and show Bone Link Up. The confirms that all devices are communicating.
Note: If you turn off Firebird X (e.g., to save battery power or change batteries) this will
stop communications to the pedals. However, turning Firebird X back on will re-establish
the link automatically after several seconds.

Pedalboard Function Selection and Display

Pedalboard Function Selection and Display
Choose the pedal function by pressing on the appropriate Pedalboard footswitches.
 Volume: Upper Left footswitch
 WahWah: Upper Right footswitch
 Octaver: Middle and Upper Right footswitch simultaneously
 Rotary Speaker: Middle and Upper Left footswitch simultaneously
After selecting the function, push down on the pedal until it clicks to toggle between effect
enabled or bypassed.
Page 21