Door Handles; Interior Light; Door Alarm (N64X, N64Xxx, N64Xim, N64Ximxx, N84X, N84Xxx, N84Xim, And N84Ximxx Models ); Moisture Reduction Heater - Norcold N62X Owner's Manual

6 cu.ft. or 8 cu. ft., 2 or 3 way refrigerators
Hide thumbs Also See for N62X:
Table of Contents

Advertisement

Available languages

Available languages

To remove or move the shelf of the freezer:
- Pull the shelf forward out of the slot.
- Push it fully into the slot that you wish.
To remove or move the shelves of the fresh food compartment:
- Remove the screws [41] from the retainer [54] on the side of
the refrigerator (See Art00992).
- Remove the retainer.
- Pull each shelf forward out of the slot.
- Push each fully into the slot that you wish.
- Install the retainer with the screws.

Door handles:

During travel, the door latch prevents the door from opening.
When closing each door, push the door toward the refrigerator
until you hear a "click" sound.
To open each door, pull the handle away from the refrigerator
(See Art00990).
During storage, the storage latch prevents the door from
completely closing. Use it to prevent odors when the refrigerator
is stored for an extended period of time.
To operate the storage latch (see Art00991), open each door
about 1/2 inch, hold the door handle in the open position, and
push the storage latch [55] into the cutout [56] of the strike plate.
Do not use the storage latch as a travel latch because the doors
will not be fully closed.

Interior light:

The interior light is at the top of the fresh food compartment. It
comes on when the refrigerator is ON and the door is open. To
replace the bulb:
1. Remove the DC power supply wires from the power board at
the rear of the refrigerator.
2. To remove the cover [57] , push it toward the rear of the
refrigerator (See Art00988).
3. Remove the light bulb [58] from the holder [59].
NOTE: Use only a GE#214-2 bulb as the replacement bulb. This
bulb is available at most retail automotive parts centers.
4. Install the replacement bulb.
5. Install the cover.
6. Connect the DC power supply wires to the power board at the
rear of the refrigerator.
Owner's Manual 4
Door alarm:
(N64X, N64XXX, N64XIM, N64XIMXX, N84X,
N84XXX, N84XIM, and N84XIMXX models)
The refrigerator has an alarm to alert you if the fresh food
compartment door is not closed. The refrigerator continues to
operate, but if the fresh food compartment door is open and the
interior light remains on for two minutes:
- An audible alarm starts.
- "dr" appears in the center display.
- The interior light automatically turns off.
Close the door to silence the alarm.

Moisture reduction heater:

The refrigerator has a heater that prevents moisture from forming
on the center divider between the doors of the freezer and the
fresh food compartment. The heater operates only when the
refrigerator is ON and the DC power is sufficient.

Temperature control system:

Although the refrigerator is not frost -free, it is made to limit frost
on the cooling fins. At regular intervals, the temperature control
system automatically melts most of the frost from the cooling
fins. The water from the cooling fins drains into a collection cup
that is attached to the back of the refrigerator. The heat of the
cooling system evaporates the water from the collection cup.

Backup operating system:

This refrigerator has a backup operating system. The backup
operating system allows the refigerator to continue to cool if the
temperature sensor of the refrigerator should fail.
If this failure occurs:
- The refrigerator automatically changes to the backup
operating system.
- When you push the TEMP SET button, the temperature
setting flashes in the center display for ten seconds.
- After the temperature setting flashes, the mode of
operation appears in the center dispaly.
- The backup operating system can overfreeze or thaw the
contents of the freezer and the fresh food compartment.
- Make sure the temperatures of the freezer and the fresh
food compartment are satisfactory.

Temperature switch monitor:

The refrigerator is equipped with a temperature switch [142] for
overheating protection (See Art01869) . A Norcold authorized
service technician can determine if this switch has been
triggered.

Advertisement

Table of Contents
loading

Table of Contents