The Alignment Tool Outline; Entering Alignment Mode; Alignment Sequence - Vertex Standard VX-160U Service Manual

Alignment
Set up the test equipment as shown below for trans-
ceiver alignment, and apply 7.5V DC power to the trans-
ceiver.
Inline Wattmeter
RF Sampling
Deviation Meter
Coupler
CT-42 connection
Cable
Frequency
Counter
The transceiver must be programmed for use in the
intended system before alignment is attempted. The RF
parameters are loaded from the file during the alignment
process.
In order to facilitate alignment over the complete op-
erating rang of the equipment, it is recommended that the
channel data in the transceiver be preset as per the chart
below.
Channels
Ver. AS1
Low Band Edge
400.000
(Channel 1)
Band Center
415.000
(Channel 2)
High Band Edge
430.000
(Channel 3)
Tone-Frequency (Hz) / DCS-code
Channel
Ver. AS1
Low Band Edge
–
(Channel 1)
Band Center
151.4
(Channel 2)
High Band Edge
–
(Channel 3)
RF Signal
Generator
Transceiver
MIC/EAR
Power Supply
P C
7.5V DC
COM port
Frequency (MHz)
Ver. D Ver. F
450.000 485.000
467.500 498.500
485.000 512.000
Ver. D Ver. F
– – – –
– 151.4 – 151.4
627 – 627 –

The alignment tool outline

Installation of the Alignment tool
The "alignment mode" is a software-based protocol,
accessed by an "Alignment Mode" command from the
computer while switching the transceiver on.It is oper-
ated by the alignment tool automatically. During use of
the alignment mode, normal operation is suspended. The
alignment tool program provides all needed operation ca-
pability.
The alignment tool consists of an executable file
"CE44.exe" and an accmpanying configuration file
"CE44.cfg" which should be loaded per standard DOS
procedures. Create a suitable directory, then copy these
foles from the distribution diskette into the new directory.
For example, if copying the file from Drive A, use the
following DOS command sequence:
c:\ mkdir align [enter]
c:\ cd align [enter]
c:\ align\ copy a:ce44.*
No further installation steps are required. If you wish
to utilize a different name for the alignment directory, it
will not matter to the executable file.
Booting the Alignment Tool
Change to the "align" directory (or the directory name
you utilized in the previous section). Now type on the com-
mand line: ce44
The introductory screen will appear, and you may press
any key to enter the main screen.

Entering Alignment Mode

To enter the alignment mode, turn the transceiver off,
Select "
transceiver back on. When the command has been suc-
cessful, a message on the computer screen will confirm
that the transceiver is now in the "Alignment" mode.

Alignment Sequence

Although the data displayed on the computer's screen
during alignment is temporary data, it is important you
follow the basic alignment sequence precisely, so that the
displayed data and the data loaded into the transceiver are
identical.
–
Basic Alignment Sequence
1. Enter the alignment mode
–
2. Upload data from transceiver
3. Align data
627
4. Download data to transceiver
to boot the alignment tool.
" then " " parameter. Now, turn the