Operating Manual Reprint - Vertex Standard VX-410 Series Service Manual

Uhf fm
Hide thumbs Also See for VX-410 Series:
Table of Contents

Advertisement

ACENT – Revenda Autorizada VERTEX | Locação | Vendas | Assistência Técnica | VENDAS: 0800 77-55-200 ou acent@radio-vertex.com.br

Operating Manual Reprint

Controls & Connectors
LED Indicator
Glows Green
Monitor on (or Side 1, 2 switch is activated : VX-410 series only)
Blinking Green Busy Channel (or SQL off)
Glows Red
Transmitting
Blinking Red
Battery Voltage is low
Yellow
Receiving a Selective Call
Antenna
Push To Talk
( PTT ) Switch
Microphone
Side 1 Switch
Side 2 Switch
LCD
(VX-420 series)
Battery Pack Latch
Display Icons & Indicators (VX-420 Only)
: "Scan" is activated
: "Priority Scan" is activated
"Dual Watch" is activated
"Encryption" is enabled
8 Character Alpha-numeric Display
Low Transmit Power Mode "ON"
2
CH ( Channel ) Selector
VOL/PWR Knob
MIC/SP Jack
( External Mic/Earphone )
Speaker
16 KEY
(VX-420 series)
"Call" indicator
Receiver Monitor
"Talk-Around" is enabled
"Voice Message" received
Group "A"
Group "B"
Priority Channel
www.radio-vertex.com.br
Before You Begin
Battery Pack Installation and Removal
Ì To install the battery, hold the transceiver with your
left hand, so your palm is over the speaker and your
thumb is on the top of the belt clip. Insert the battery
pack into the battery compartment on the back of the
radio while tilting the Belt Clip outward, then close
the Battery Pack Latch until it locks in place with a
"Click."
Ì To remove the battery, turn the radio off and remove
any protective cases. Open the Battery Pack latch on
the bottom of the radio, then slide the battery down-
ward and out from the radio while holding the Belt
Clip.
Do not attempt to open any of the rechargeable Ni-
Cd packs, as they could explode if accidentally short-
circuited.
Low Battery Indication
Ì As the battery discharges during use, the voltage gradu-
ally becomes lower. When the battery voltage becomes
to low, substitute a freshly charged battery and recharge
the depleted pack. The TX/BUSY indicator on the top
of the radio will blink red when the battery voltage is
low.
Ì Avoid recharging Ni-Cd batteries often with little use
between charges, as this can degrade the charge capac-
ity. We recommend that you carry an extra, fully-
charged pack with you so the operational battery may
be used until depletion (this "deep cycling" technique
promotes better long-term battery capacity).
Insert the Battery Pack
Close the Battery Pack Latch

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vx-420 series

Table of Contents