Hazard Warning Flashers; Fuel Shutoff; Jump-Starting The Vehicle; To Connect The Booster Cables - Ford TRANSIT CONNECT Owner's Manual

HAZARD WARNING FLASHERS

Note: If used when the vehicle is not
running, the battery will lose charge. There
may be insufficient power to restart your
vehicle.
The hazard warning button is
located on the instrument panel.
Use it when your vehicle is
creating a safety hazard for other
motorists.
• Press the button to turn on the hazard
warning function, and the front and
rear direction indicators will flash.
• Press the button again to turn them
off.

FUEL SHUTOFF

WARNING
Failure to inspect and, if necessary,
repair fuel leaks after a collision may
increase the risk of fire and serious
injury. Ford Motor Company recommends
that the fuel system be inspected by an
authorized dealer after any collision.
In the event of a moderate to severe
collision, this vehicle is equipped with a
fuel pump shut-off feature that stops the
flow of fuel to the engine. Not every impact
will cause a shut-off.
Should your vehicle shut off after a
collision, you may restart your vehicle by
doing the following:
1. Turn the ignition off.
2. Turn the ignition to crank.
3. Turn the ignition off.
4. Turn the ignition on again to re-enable
the fuel pump.
Tourneo Connect/Transit Connect (CHC) Canada/United States of America
Roadside Emergencies
157

JUMP-STARTING THE VEHICLE

WARNINGS
Do not use fuel lines, engine rocker
covers or the intake manifold as
grounding points.
Connect batteries with only the same
nominal voltage.
Always use booster cables with
insulated clamps and adequate size
cable.
Note: Do not disconnect the battery from
your vehicle s electrical system.

To Connect the Booster Cables

A
C
E102925
A Vehicle with low charge battery
B Booster battery vehicle
D
B