Instrument Lighting Dimmer; Headlamp Exit Delay; Daytime Running Lamps; Automatic Main Beam Control - Ford TRANSIT CUSTOM Owner's Manual

Hide thumbs Also See for TRANSIT CUSTOM:
Table of Contents

Advertisement

The headlamps will switch on and off
automatically in low light situations or
during inclement weather.
The headlamps will remain on for a period
of time after you switch the ignition off.
You can adjust the time delay using the
information display controls. See
Information Displays (page 56).
Note: If you switch autolamps on in
conjunction with autowipers, dipped beam
headlamps will illuminate automatically
when the rain sensor turns on the
windscreen wipers continuously.
INSTRUMENT LIGHTING
DIMMER
Note: If you disconnect the battery or it
loses charge, the illuminated components
will switch to the maximum setting.
Press repeatedly or press and hold until
the desired level is reached.
Transit Custom (TTF) Vehicles Built From: 14-01-2013
Lighting

HEADLAMP EXIT DELAY

After you switch the ignition off, you can
switch the headlamps on by pulling the
direction indicator lever toward you. You
will hear a short tone. The headlamps will
switch off automatically after three
minutes with any door open or 30 seconds
after the last door has been closed. You
can cancel this feature by pulling the
direction indicator toward you again or
switching the ignition on.

DAYTIME RUNNING LAMPS

Always remember to switch your
headlamps on in low light situations
or during inclement weather. The
system does not activate the tail lamps
and may not provide adequate lighting
during these conditions. Failure to switch
the headlamps on under these conditions
may result in a collision.
To switch the system on:
Switch the ignition on.
Switch the lighting control to the off or
autolamp position when the outside
ambient light level is high.
AUTOMATIC MAIN BEAM
CONTROL
The system does not relieve you of
your responsibility to drive with due
care and attention. A manual
override may be necessary if the system
fails to switch the main beam on or off.
A manual override may be required
when approaching other road users
such as cyclists.
42
WARNING
WARNINGS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents