Registering The 5505 Guest Ip Phone - Mitel 5505 Administration Manual

5505 Guest IP Phone Administration Guide

Registering the 5505 Guest IP Phone

The 5505 Guest IP Phone comes pre-paired with one 5505 Cordless Handset. Follow the
instructions below to register the 5505 Guest IP Phone.
Note: This procedure is valid only for first-time registration. See "Re-Registering the 5505 Guest
IP Phone" on page 16, if necessary.
1. Turn on the 5505 Cordless Handset using the power on button
2. Place the handset with the display facing up in the 5505 Guest IP Phone base.
If the phone has not been registered previously, the LEDs on the base start flashing in the
order below:
• Speakerphone: LLDP & IP provisioning
• Mute: Upgrade firmware
• Messages: Upgrade CVM firmware
• Line In Use: Successful boot up. The display on the handset displays "NO DN
PROGRMED".
3. Enter the DN and the user PIN as DN#PIN#. In ESM, refer to User and Device Configuration
-> Access Authentication -> User PIN.
4. Press the Speaker key.
After successful registration, the screen displays the Room Name/Number.
See "Pairing the 5505 Cordless Handsets" on page 12 to continue pairing additional handsets.
10