Targus LAPTOP DOCKING STATION User Manual page 4

Targus USB 2.0 Laptop Docking Station with Video
Installing the Device and Drivers
To use the Targus Docking Station, you must first install the driver onto your
computer. Then, connect the docking station to your computer and Windows
plug-and-play will install the hardware drivers for each port.
WARNING: YOU MUST INSTALL THE DOCKING STATION SOFTWARE BEFORE
CONNECTING IT TO YOUR COMPUTER. OTHERWISE, THE DOCKING STATION
WILL NOT WORK PROPERLY.
Installing the Docking Station Driver
Installing the docking station driver enables your operating system to
recognize the docking station and its ports once it's connected.
1 Turn on your computer.
2 Insert the driver software CD into your computer's CD-ROM drive.
If setup does not begin automatically, click Start, Run, and enter D:\
Setup.exe (where D: is the path of your CD-ROM drive) and then click OK.
3 Follow any on-screen instructions to complete the installation.
4 Click Finish and restart your computer when prompted.
6
Targus USB 2.0 Laptop Docking Station with Video
Connecting the Docking Station to
Your Computer
After installing the docking station software, you are ready to connect the
docking station to your computer. To do this:
1 Connect the supplied AC power adapter to the AC power jack on the docking
station.
2 Connect one end of the USB cable to the docking station and the other end
into an available USB 2.0 port on your computer.
WARNING: THE DOCKING STATION WILL NOT FUNCTION PROPERLY
WITHOUT THE AC ADAPTER PLUGGED INTO AN AC OUTLET.
DO NOT CONNECT ANY DEVICES TO THE DOCKING STATION UNTIL THE
INSTALLATION IS COMPLETED.
7