Graco Hydra-Clean 800-233 Instructions-Parts List Manual page 4

1. Remove the two hood bolts, flats and locks, from
the center bottom of each side of the hood. Pivot
the hood open.
2.
Position the handle into the end
closest to the wheels. Line up the four mounting
holes. Install the four
outside of the chassis. Use flat washers only on
head of bolt. Use a flat washer, lock washer, and
nut on each bolt on the inside of the chassis.
3.
Connect one end of the
hose to the pump outlet. This connection is made
with a threaded swivel fitting. Connect the other
end to the gun using the quickcouplers provided,
4 002-777
, .
.
. .. .. . . . . ,
of the chassis
318
1
x inch bolts from the
30
foot high pressure
p e r f o r m a n c e , a n d c h e m i c a l i n j e c t o r
performance.
now
4. Hood may be closed and secured with hood
bolts, flat washers, and lock washers removed in
Steu 1 .
5. Remove the plastic plug from the inlet hose.
Check the water supply flow rate (see page 5).
Connect inlet hose to water supply. A standard
3/4"
garden hose may be-used to connect inlet
hose to the water supply.
. .
..
.
i..
.>
..
~. .
, .
.... ,
. .
:
..
.
..' ,.:
. ..