Table of Contents
Advertisement
~
HAZARD
eapleoai
,
.
Safeuy
Any misuse of the pressure washer or accessories,
such as overpressurizing, modifying parts, using
incompatible chemicals and fluids, or using worn
damaged parts, can cause them to rupture and result
in fluid injection, splashing in the eyesor ontheskin,
or other serious bodily injury or property damage.
NEVER alter or modify any part of this equipment,
doing so could cause
CHECK all cleaning equipment regularlyand repairor
replace worn or damaged parts immediately.
If using a chemical injector, read and follow the
chemical manufacturer's literatureregarding the use
of protective eyewear, clothing and equipment.
$yStWDl
Pl'eSSM6e
This sprayer can develop
MAXIMUM WORKING PRESSURE. Be sure that all
spray equipment and accessories are rated
withstand the maximum working pressure of this
sprayer. DO NOT exceed the maximum working
pressure of any component or accessory used in the
system.
Chemical Compatibility
BE SURE that all chemicals used in the chemical
injector are compatible with the wetted parts of the
hose, gun, wand and
Data on the back cover. Always read the chemical
manufacturer's literature before using any chemical
in this pressure washer.
High pressure fluid in the
dangerous. If the hose develops a leak,.split or
rupture due to any kind of wear, damage or misuse,
the high pressure spray emitted from
fluid injection injury or other serious bodily injury
property damage.
TIGHTEN all fluid connections securely before each
use.Highpressurefluidcandislodgealoosecoupling
or allow high pressure spray to be emitted from the
coupling.
~
to malfunction.
it
bar)
1800
(123
psi
as given
the Technical
tip,
in
hoses can be very
it can cause a
~
a
NEVER use
damaged hose. Before each use, check
entire hose for cuts, leaks, abrasion, bulging cover, or
damage or movement of the hose couplings.
these conditions exist, replace the
DO
NOT try to recouple high pressure
or
with tape or any other device. A repaired hosecannot
contain the high pressure fluid.
HANDLE AND ROUTE HOSES CAREFULLY. Do not
pull on hoses to move the pressure washer.
use chemicals which are not com.patible with the
inner tube and cover of the hose.
Graco hose to temperatures above 200OF (94OC) or
below -4OOF (-4OoCJ.
~~~~~~~~A~ ~
NEVER operate the pressure washerwithouttheunit
being properly grounded. This includes internal
wiring on unit, plug (ground plug
building wiring.
conductor, it is very important to provide a good
to
ground circuit to
equipment should fail.
Moving parts can pinch or amputate your fingers or
other body parts. KEEP CLEAR of moving parts when
starting or operating the pressure washer. Followthe
Pressure Relief Procedure, page
or servicing the pressure washer
discharging high pressure fluid from the gun.
IMPORPAMB
United States Government safety standards have
been adopted under the, Occupational Safety and
Health Act. These standards-particularly the
General Standards, Part 191 0, and the Construction
Standards, Part 1926-should be consulted.
or
TERMS
W V A i ~ b J u k G :
Alerts
conditions that could cause bodily injury.
CAUTION:
Alerts
conditions that could cause damage to or destruction
of equipment.
NOTE:
I d e n t i f i e s h e l p f u l p r o c e d u r e s a n d
information.
~
If
hose immediately.
hose or mend it
DO
NOT expose
~
~
must be intact), and
is a natural
Because water
avoid serious bodily injury if
2,
before checking
to prevent
user to avoid or correct
user to
avoid or correct
802-777
~
any of
Do
not
A
>..
s .
. .
3
Advertisement
Table of Contents
