Installing The Cutter Motor And Paper Door Assembly - Toshiba SureMark 4610 Service Manual

Removing and replacing FRUs
B
A
Figure 33. Clearing the drag strip detent
c. Repeat steps 5a on page 59 and 5b on page 59 to remove the second spring; then continue on to
the next step.
d. Lift the tip of the drag strip ( A in Figure 33) while opening the paper door assembly further, so
that the tab at the end of the drag strip clears its detent.
e. Align the square opening of the door assembly hinge must align with the flat sides of the posts;
then, lift the paper door assembly off its posts.

Installing the cutter motor and paper door assembly

This section provides the information needed to install the cutter door and paper door assembly in a fiscal
or fiscal ready printer.
To install the cutter motor and paper door assembly, complete the following steps:
1. Position the door assembly over the posts; then, align the hinges on the door assembly with the posts
on the unit.
2. Set the door assembly on to the posts and hold it in the fully open position.
3. Align the drag strip with the retention bracket on the side of the unit.
4. Close the door assembly slightly while inserting the drag strip into the retention bracket. You will hear
the drag strip click as it passes the detent.
Note: Do not close the door completely.
5. Install the lift spring:
a. Orient the printer unit with one side facing you.
b. Orient the spring with the short leg facing up and toward the printer unit frame.
c. Place the spring onto the post and rotate the short leg of the spring enough to avoid contact with
the paper door assembly.
60
SureMark Hardware Service