Analog; Digital; Lip Sync; Setting The Analog Audio Input - Krell Industries EVOLUTION 707 Owner's Reference Manual

Main Menu, Navigation and Setup Cont...
Main Audio input device options are:
1.

Analog

a. CAST – C1, C2
b. Balanced – B1
c. Single-ended – S1, S2, S3, S4, S5
d. Tape – Tape Fixed Single-ended Input
e. VCR – Dedicated VCR Single-ended input
f. 5.1 PRE – Dedicated direct 5.1 channel analog input
2.

Digital

a. HDMI A – Auto Signal detection.
HDMI A is used when the source component utilizes the I
Interchip Sound) is the carrier for all of the new uncompressed formats ie TrueHD,
DTS-HD Master audio etc... HDMI A should be the default HDMI setting for use with
uncompressed PCM or Bitstream sources.
NOTE: In order to receive uncompressed formats the video output of the source
device must be set to 720p or higher.
b. HDMI S – S/PDIF Signal mode.
Decodes from the standard HDMI audio transport known as S/PDIF typically used for
earlier sources that have audio over HDMI in an S/PDIF format. For this type of source
use the HDMI S option. These source units may not transfer audio on the advanced
HDMI audio transport. NOTE: HDMI audio inputs are defi ned by the Video selection.
c. S/PDIF Optical (TOSLINK) – OPT 1, OPT 2, OPT 3, OPT 4
d. S/PDIF Coaxial – COAX 1, COAX 2, COAX 3, COAX 4
e. Disabled - No audio input selected, no audio will pass.
f. Previous - Outputs the last active audio input selected.
C. Choose an Analog Decode Preference
The Analog decode preference is a processor mode that can be triggered when the analog
input signal is sent to the processor. The Preamp mode is a direct connection to the Volume
control and does not use and signal processing designed for best analog performance.
The analog decode modes are:
STANDARD DECODE MODES
1. Dolby PLIIx Movie
2. Dolby PLIIx Music
3. DTS NEO: 6 Cinema™
4. DTS NEO: 6 Music™
2 S protocol. I 2 S (Integrated