250Mc, 350Mc, And 650Mc Monaural Power Amplifiers - Krell Industries 200c Instructions For Use Manual

Back Panel Description,
continued
FULL POWER BALANCED 250Mc,
350Mc, AND 650Mc MONAURAL
POWER ,AMPLIFIERS
See Figure 4 on page 10
20 Handle
All Full Power Balanced monaural amplifiers are
equipped with a handle, located beside the
speaker binding posts, to help you easily and
safely move the amplifier.
21 Speaker Binding Posts
Full Power Balanced 250Mc, 350Mc, and
650Mc monaural amplifiers are equipped with
two pairs of speaker binding posts (one upper
pair and one lower pair). For stereo operation,
two monaural amplifiers are required.
22 Krell CAST Input
Full Power Balanced 250Mc, 350Mc, and
650Mc monaural amplifiers are equipped with
one Krell CAST input via a 4-pin bayonet con-
nector. The Krell CAST input allows the Full
Power Balanced amplifier to be connected to
the KPS 25sc Krell Playback System and other
CAST-equipped components.
23 Balanced Input
Full Power Balanced 250Mc, 350Mc, and 650Mc
monaural amplifiers are equipped with one bal-
anced input via an XLR connector.
24 AC Mains Power Cord
All Full Power Balanced amplifiers are equipped
with a permanently attached AC power cord.
25 Krell Link Out/In
Full Power Balanced amplifiers are equipped
with Krell Link Remote out/in connectors that
allow the remote control to operate a linked
amplifier configuration. See Krell Link Connec-
tions, on page 13 for more information.
Note
An optional remote control is available for Furl
Power Balanced amplifiers.
26 Back Panel Power Breaker Switch
Full Power Balanced amplifiers are equipped
with a back panel power breaker switch, for
powenng on the amplifier. Powering on u§ing
the back panel power breaker switch places the
amplifier in stand-by mode, where it remains
until the front panel power button is pressed.
Note
Krell recommends that, once the amplifier is
powered on from the back pane/power breaker
switch, it remains on, in stand-by mode, even
when not in use.
12
Krell Full Power Balanced Power Amplifiers