Warnings - Graco Hydra-Clean 308-530 Instructions-Parts List Manual

HIGH PRESSURE SPRAY CAN CAUSE SERIOUS INJURY.
FOR PROFESSIONAL USE ONLY. OBSERVE ALL WARNINGS.
Read and understand all instruction manuals before operating equipment.
FLUID INJECTION HAZARD
General Safety
This pressure washer generates very high fluid pressure.
Spray from the gun, leaks or ruptured components can
inject fluid through your skin and into your body and
cause extremely serious bodily injury including the need
for amputation. Also, fluid injected or splashed into the
eyes or on the skin can cause serious damage.
NEVER point the spray gun or wand at anyone or at any
part of the body . NEVER put hand or fingers over the
spray tip.
ALWAYS follow the Pressure Relief Procedure, before
cleaning or servicing any part of the sprayer.
NEVER try to stop or deflect leaks with your hand or
body.
Be sure equipment safety devices are operating properly
before each use.
Medical Treatment
If any fluid appears to penetrate your skin, get
EMERGENCY MEDICAL TREATMENT AT ONCE. DO
NOT TREAT AS A SIMPLE CUT. Tell the doctor exactly
what fluid was injected.
NOTE T O PHYSICIAN: Injection in the skin is a
traumatic injury . It is important to treat the injury
surgically as soon as possible.
treatment to research toxicity . T oxicity is a concern
with some exotic coatings injected directly into the
bloodstream. Consultation with a plastic surgeon or
reconstructive hand surgeon may be advisable.
MOVING PARTS HAZARD
Moving parts can pinch or amputate fingers or other body
parts. KEEP CLEAR of moving parts when starting or
operating the pressure washer.
NEVER operate the pressure washer without all guards
and interlocks installed and functioning. Follow the
Pressure Relief Procedure
WARNING
Do not delay
before checking or
Pressure Relief Procedure
To reduce the risk of serious bodily injury, including fluid
injection and splashing in the eyes or on the skin, always
follow this procedure whenever you stop spraying for
more than 10 minutes, when shutting down, and before
checking or repairing any part of the system.
1. Engage the trigger safety latch.
2. Turn the sprayer off.
3. Remove the ignition cable from the spark plug.
4. Shut off the water supply.
5. Disengage the trigger safety latch and trigger the gun
to relieve pressure, and then engage the trigger
safety latch again.
6. Before long–term (overnight) storage or transporting
of the unit, disconnect the water supply and turn off
the fuel supply valve.
Spray Gun Safety Devices
Be sure all gun safety devices are operating properly
before each use. Do not remove or modify any part of the
gun; this can cause a malfunction and result in serious
bodily injury.
SAFETY LATCH: Whenever you stop spraying for a
moment, always set the gun safety latch in the engaged
or "safe" position, making the gun inoperative. Failure to
properly set the safety latch can result in accidental
triggering of the gun.
SPRAY TIP SAFETY : Use extreme caution when
cleaning or changing spray tips. If a spray tip clogs while
spraying, engage the gun safety latch immediately
ALWAYS follow the Pressure Relief Procedure and
then remove the spray tip to clean it.
servicing the pressure washer to prevent discharging
high pressure fluid from the gun.
Warnings continued on page 4.
.
308–530