Installing Your Trim Strip Accessory - Williams 3144030 Owner's Manual

Installing Your Trim Strip Accessory

Trim Strip Accessory 4701
When desired, optional Trim Strip Kit may be used to cover the
crack between heater and wall See Figure 12.
Place strips tight against heater with other edge against wall
surface and fasten to wall with escutcheon pins provided. Cut
off trim strips to fit each heater as required.
FIGURE 12 – Heater Trim
FIG. 8
HEATER TRIM
14
NOTE
Quarter-round wood molding may be used for trim if desired.
Trim Cover (Surface Mount)
1. To conceal the heater wiring, set top trim cover inside the
flanges of heater top.
2. Fasten to the heater cabinet with (2) short screws
provided.
Trim Cover (Recessed Mount)
1. Trim off the back edges of the top trim cover (a little at
a time) until it fits between the front cabinet flange and
the wall.
2. When trimmed to your satisfaction, set in place on heater
top and drill (2) #33 holes through top trim cover and
heater side flanges.
3. Fasten cover to heater with (2) short screws provided.