Zenoah PSJ2310 Owner's Manual page 8

Table of Contents

Advertisement

PSJ2310
6. Set up
4. Adjust the chain tension by turning the chain tension
adjust screw until the saw chain does not sag from
the underside of the bar.
(1)
(b)
(a)
5. Tighten the nut securely with the bar tip held up.
Then check the chain for smooth rotation and
proper tension while moving it by hand.
If necessary, readjust with the cahin cover loose.
(1)
WARNING
It is very important to maintain the proper chain
tension. Rapid wear of the guide bar or the chain
coming off easily can be caused by improper ten-
sion. Especially when using a new chain, take good
care of it since it should expand when first used.
Make sure that there is 3-4mm clearance between the
saw chain and the guide bar when gently picking up
the saw chain with fingers.
NOTE
Before installing the new saw chain on the guide bar,
immerse the saw chain in the chain oil for one night to
obtain smooth chain movement and better oil take up.
GB-8
01-PSJ2310_GB_209_三.indd 8
HARNESS
ALWAYS WEAR THE PROVIDED HARNESS WHEN
USING THE MACHINE!
Always make sure the machine is hooked securely
to the harness.
If you don't, you will be unable to control the ma-
chine safely. This can result in injury to yourself or
(1) Chain tension adjust
others.
screw
Never use a harness with a defective quick release
(a) Loosen
or any other damage.
(b) Tighten
HOW TO WEAR
1. Wear the provided harness without twisted bands,
(1) Tighten
BALANCE UNIT
1. Put on harness and attach unit to harness.
2. Depending on the working posture, slide clamp up or down
QUICK RELEASE
The harness is equipped with a "QUICK RELEASE"
devise.
To release the machine from the harness in emergency
situations, please follow the procedure as explained
below.
Make sure to check proper working of the QUICK
RELEASE device BEFORE operating the machine.
Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your left hand securely, press
both sides of the buckle.
WARNING
with the hanger on your right side.
(1) Hanger
(1)
until unit balances and the harness fits your body.
WARNING
(1) Buckle
(Single harness)
(Single harness)
(1)
12.9.12 1:09:29 PM

Advertisement

Table of Contents
loading

Table of Contents