Pinion Assembly/Rotor/Field/Shaft/Clutch
Removal
If pinion assembly (19) is not removed from clutch
housing (5), do 1. through 4. Otherwise, start at 5.
1.
Relieve pressure; page 5.
2. Remove drive housing; page 9.
3. Disconnect field cable (X) from pressure control,
and gallon counter sensor at (A).
X
Fig. 4
4. Fig. 5. Remove five screws (10) and lockwashers
(17) and pinion assembly (19).
10
17
Fig. 5
5. Fig. 6. Place pinion assembly (19) on bench with
rotor side up.
6. Remove four screws (72) and lockwashers (17).
Install two screws in threaded holes (E) in rotor.
Alternately tighten screws until rotor comes off.
10
309409
A
Bottom View
8699A
10
17
19
8700A
72
17
E
Fig. 6
8701B