Appendix 1 Led Indication - Toshiba B-450-R SERIES Owner's Manual

APPENDIX 1 LED INDICATION

APPENDIX 1 LED INDICATION
Symbols in the message
: The LED is illuminated.
LED Indication
No.
POWER ONLINE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
: The LED is flashing.
Printer Status
ERROR
Online mode
Online mode (communicating)
The print head block is opened in
online mode.
Pause state
A parity, overrun, or framing error
has occurred during a
communication by RS-232C.
A paper jam has occurred during
paper feed.
A problem has occurred at the cutter
module.
The media has run out, or the media
is not loaded properly.
A feed or an issue was attempted
with the print head block opened.
(Except when the [FEED] key is
pressed.)
The print head has a problem.
The print head is overheated.
• The ribbon has run out.
• The ribbon has been torn. A
problem has occurred with the
sensor that determines the torque
for the ribbon motor.
A feed or printing was attempted
with the Front Cover opened.
In writable character or PC
command save mode
An error has occurred in writing to
the flash ROM.
An error has occurred in formatting
the flash ROM.
Saving failed because of an
insufficient capacity of the flash
ROM.
A command error has occurred in
analyzing the command.
A momentary power failure has
occurred.
The flash ROM is being initialized.
Data cannot be read from/written to
a backup EEPROM properly.
: The LED is unlit.
Restoration by PAUSE
key Yes/No
A1-1
APPENDIX 1 LED INDICATION
Acceptance of Status
Request Reset
Command Yes/No
----- Yes
----- Yes
----- Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
----- Yes
No Yes
No Yes
No Yes
Yes Yes
No No
----- -----
----- -----
EO1-33076