Connect and install radio
1
Connect one end of the supplied FM
antenna to the FM75
subwoofer.
2
Fasten the other end of the antenna to a
wall or furniture.
Tip
•
For the best reception, place the antenna away
from your TV or other sources of radiation.
•
For even better reception of FM stereo,
connect an external FM antenna (not
supplied).
Install radio stations
1
Press RADIO on the remote control.
2
Press .
»
The message ''
PROGRESS ' is displayed and the home
theater searches for and stores radio
stations. After installation, the home
theater plays the À rst radio station it
found.
Note
•
The home theater can store up to 40 radio
stations.
•
You can press
to stop the installation.
•
If you do not complete the installation, or if
fewer than À ve stations are found, you are
prompted to install the radio stations again.
•
If fewer than À ve stations are found or if a
stereo signal is not detected, check that the
FM antenna is connected correctly.
14
EN
FM ANTENNA
FM 75
connector on the
INSTALLATION IN
Reinstall radio stations
1
Press RADIO .
2
Press and hold PROGRAM for 5 seconds.
»
The home theater searches for and
stores radio stations. All previously
stored stations are replaced.
Tune radio stations manually
You can manually tune radio stations.
1
Press RADIO , then press
»
The home theater searches for radio
stations and stops searching when it
À nds a station.
2
Press
or
until you À nd a station you
like.
3
Press
or
to À ne tune the station.
4
Press PROGRAM .
»
The preset station number blinks.
5
Within 20 seconds, press
number buttons to select a number for
the radio station.
If you wait for more than 20 seconds, the
home theater exits the installation.
6
Press PROGRAM to conÀ rm the station
number.
»
The radio station is stored with the
selected channel number.
or .
,
or the