24) Remove the Front Panel.
25) Remove one end of the Pump Tubing. Drain the Water Tank. Replace the Pump Tubing
in its correct position.
26) Repeat the above steps 14) through 25) three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to the step 10) in "[b] SANITIZING
PROCEDURE."
[b] SANITIZING PROCEDURE - Following Cleaning Procedure
1) Dilute IMS-II Sanitizer or a 5.25% Sodium Hypochlorite solution with water (Add 1.5 fl. oz.
of sanitizer to 3 gal. of water).
Note: IMS-II Sanitizer, Part #SA0004, is available through your Hoshizaki Dealer.
2) Remove the Insulation Panel.
3) Pour the sanitizing solution into the Water Tank.
4) Replace the Insulation Panel and the Front Panel in their correct position.
Note: Make sure that the Control Switch is in the "WASH" position and the Cleaning Valve
is open.
5) Turn on the power supply, and start the sanitizing process.
6) Turn off the power supply after 15 minutes.
7) Remove the Front Panel.
8) Remove one end of the Pump Tubing. Drain the Water Tank. Replace the Pump Tubing
in its correct position.
9) Repeat the above steps 14) through 25) in "[a] CLEANING PROCEDURE" two times to rinse
thoroughly.
10) Close the Cleaning Valve.
11) Move the Control Switch to the "ICE" position.
12) Replace the Front Panel and the Base Cover in their correct position.
13) Clean the Storage Bin with water.
14) Turn on the power supply, and start the automatic icemaking process.
24
A1JA10A9810