Toyota Tacoma 1998 Operating Manual page 82

Hide thumbs Also See for Tacoma 1998:
Table of Contents

Advertisement

NOTICE
z Be careful not to overrev the en-
gine. Watch the tachometer to keep
engine rpm from going into the red
zone. The approximate maximum al-
lowable speed for each position is
given below for your reference:
"2"
. . .
136 km/h (85 mph)
"L"
. . .
74 km/h (46 mph)
z Do not continue hill climbing for a
long time in the "2" or "L" posi-
tion. This may cause severe auto-
matic
transmission
damage
overheating. To prevent such dam-
age, use "D" position for hill climb-
ing or hard towing.
(d) Backing up
1. Bring the vehicle to a complete stop.
2. With the brake pedal held down with
your foot, shift the selector lever to the
"R" position.
NOTICE
Never shift into reverse while the ve-
hicle is moving.
82
(e) Parking
1. Bring the vehicle to a complete stop.
2. Pull the parking brake lever fully to
securely apply the parking brake.
3. With the brake pedal pressed down,
shift the selector lever to the "P" posi-
tion.
CAUTION
While the vehicle is moving, never
attempt to move the selector lever
into "P" position under any circum-
stances. Serious mechanical damage
from
and loss of vehicle control may re-
sult.
(f) Good driving practice
"
If the transmission is repeatedly up-
shifted and downshifted between third
gear and overdrive when climbing a
gentle
slope,
the
should be turned off. Be sure to turn
the switch on immediately afterward.
"
When towing a trailer, in order to main-
tain engine braking efficiency, do not
use overdrive.
'98 Tacoma (U)
Always keep your foot on the brake
pedal while stopped with the engine
running. This prevents the vehicle
from creeping.
Do not hold the vehicle on an up-
grade with the accelerator pedal. It
can cause the transmission to over-
heat. Always use the brake pedal or
parking brake.
(g) Driving in "POWER" mode
In the "POWER" mode, the transmission
is shifted up and down at a higher vehicle
speed than in the "NORMAL" mode and a
more powerful acceleration is achieved. To
set the "POWER" mode, push in the driv-
overdrive
switch
ing pattern selector button. The POWER
mode indicator light comes on.
For ordinary driving, Toyota recommends
using the "NORMAL" mode to improve fuel
economy.
CAUTION
NOTICE

Advertisement

Table of Contents
loading

Table of Contents