Harman Stove Company Advance Installation & Operating Manual page 8

Read these instructions carefully before you attempt
to install or operate the Advance. Failure to do so may
result in damage to property or personal injury and may
void the product warranty.
Consult with your local building code agency and
insurance representative before you begin your installa-
tion to ensure compliance with local codes, including the
need for permits and follow-up inspections.
Several issues must be addressed when selecting a
suitable location for your Advance Pellet Stove. Observ-
ing required clearances to combustible materials, the
proximity to a safe chimney or venting system, and the
accessibility of electrical supply must all be considered.
In addition, selecting a location that takes advantage of
the building's natural air flow is also desirable to maximize
the heating effectiveness of the heater. In many cases,
this is a central location within the building.
Adequate combustion and ventilation air must be
provided.
Place the stove on a noncombustible floor or UL ap-
proved floor protector that extends 6 inches to the front,
6 inches to the sides and 1 inch to the rear of the stove.
Fig. 8.
Place the stove away from combustible walls at least
as far as shown in figures 6, and 7.
Note that the clearances shown are minimum for
safety, but do not leave much room for access when
cleaning or servicing. Please take this into account when
placing the stove.
mobile home Installation
When installing this stove in a mobile home several
requirements must be followed:
1. The unit must be bolted to the floor. This can
be done with 1/4" lag screws through the 2 holes in
the base plate shown in Fig. 13, Page 9.
2. The unit must also be connected to outside air.
See page 12.
3. Floor protection and clearances must be fol-
lowed as shown to right.
4. Unit must be grounded to the metal frame of
the mobile home.
5. The unit may not be installed in a bedroom.
CAuTION: This appliance must be vented to
the outside.
Due to high temperatures, the stove should be
placed out of traffic and away from furniture and drap-
eries.
Children and adults should be alerted to the haz-
ards of high surface temperatures and should stay away
to avoid burn to skin and/or clothing.
Young children should be carefully supervised
when they are in the same room as the stove.
Clothing and other flammable materials should not
be placed on or near the stove.
Installation
6"
FLOOR
PROTECTOR
Installation and repair of this stove should be done
by a qualified service person. The appliance should
be inspected before use and at least annually by a
qualified service person. More frequent cleaning will
be required. It is imperative that control compartments,
burners, and circulating air passageways of the stove
be kept clean.
AFTEr ThE INSTAllATION IS COmPlETEd
Before the first fire is lit, check and record the
high and low draft reading numbers on page 10.
make adjustments to the low draft at this time, if
necessary. See page 10.
8
7"
Fig.6
1"
Fig.7
1"
6" From Glass
Fig.8
7"
10"
6"