Harman Stove Company Advance Installation & Operating Manual page 23

maintenance - Combustion Intake Cover
Cover Retainer Handle
Fig. 46
These surfaces must be even to
close retainer handle.
Fig. 47
Intake Cover Handle
ESP Probe
(in rear of flue
tube)
Fig.48
Combustion
Intake Cover
Right Side Tab
Right Side Retaining Slot
Combustion Fan Blade
Cleaning and maintenance for the
Combustion Intake Cover
You will need to remove the combustion intake
cover to clean the fan blades and rear flue tube.
Rotate the retainer cover handle counter-clockwise
upward as far as it will go (approximately 90
Hold the intake cover handle and pull until the side
of the cover at the retainer handle end comes away
from the stove body, approximately 15-20
right side tab out of the retaining slot.
Clean and inspect the fully exposed combustion fan
blade and flue tube.
Reinstall the combustion intake cover by first
sliding the right side tab into the retainer slot seen in
Figure 47.
Rotate the cover inward until the cover fits
into its hole.
Make sure the two faces (Fig.46) of the cover
and retainer spacer are even and rotate the retainer
handle clockwise until it stops.
Excessive cleaning force could bend the
small stainless steel ESP Probe, causing
need to be cleaned. Note the location of the
muffler and use care when cleaning the hop-
per area. Blockage or failure will cause the feeder
to stop.
23
Figure 6
Figure 7
, slide the
o
Figure 8
CAuTION
damage.
The low draft
sensor monitors
the air pressure
through a fitting
in the hopper.
Depending on
the amount of
fines in the fuel
being burned,
this fitting ,
known as the
muffler, may
).
o