Replacing The Battery - Husky FS3 User Manual

Alternatively, if your system includes the H
Communications & Charging Rack, you can
recharge a unit by placing it on the Rack.

Replacing the battery

Turn off the FS3.
Remove the battery cap by using a suitable coin.
Do not allow rain or moisture into the battery
compartment.
Tilt the unit to slide out the battery pack.
Slide the replacement H
into the battery compartment, positive end first.
Refit the battery cap. Seat it with finger pressure
first and make sure that it has engaged the screw
threads before tightening it with a suitable coin.
Turn on the FS3 and check operation.
If you can't turn on, you may need to reset the
FS3 as described in the CONTROLS section.
After changing the battery, you MUST ensure
that the battery type, capacity and power
management are correctly set. (Refer to your
application's user instructions.)
CAUTION: Alkaline batteries are not generally
recommended for use with the FS3 and should only
be fitted in an emergency, as a temporary measure, or
for light duty applications. If you fit them, warn
anyone you give the unit to – non-rechargeable
batteries must NOT be recharged.
Always use batteries of the same type and charge
state – don't mix fresh batteries with used batteries,
or rechargeable batteries with non-rechargeable ones.
Observe the instructions printed on the battery.
Replace only with batteries approved by your FS3
supplier. DO NOT FIT LITHIUM BATTERIES.
ATTENTION: Dispose of or recycle used batteries
according to the manufacturer's instructions, or local
waste management regulations. Nickel-Cadmium
rechargeable batteries must be recycled, or disposed
of properly. Do not dispose of batteries in fire.
CAUTION: BATTERY CHEMICAL LEAKAGE IS
CORROSIVE. In the unlikely event of battery leakage,
do not touch. In case of accidental contact, flush
immediately with running water.
FS
USKY
FS3 battery pack
USKY