Charging The Battery - Husky FS3 User Manual

THE BATTERY
The FS3 is designed for use with a rechargeable
battery pack. Use the H
Non-rechargeable alkaline batteries are not
generally recommended for use with the FS3,
except for light duty applications with no peripheral
loads. Alkaline batteries are not suited to low
temperature operation.
With a full charge, the FS3 battery is designed to
last more than a working shift. However, if power
does run low, a warning BATTERY LEVEL LOW will
be displayed. (After a further period of use, your FS3
will turn itself off and will not turn on again.) You
should do one of the following:
Return the FS3 to your base or office
Or recharge the battery (see Charging the
battery)
Or fit a fully charged battery pack (see Replacing
the battery)
Or in an emergency only, fit three new AA size
alkaline batteries as a temporary measure.

Charging the battery

Charging is recommended before each working shift.
You will need an FS3 AC Adaptor.
CAUTION: DO NOT ATTEMPT TO RECHARGE
NON-RECHARGEABLE BATTERIES. DAMAGE TO
THE FS3 WILL RESULT
rechargeable battery pack is fitted to your FS3,
and oriented correctly. Use only the FS3 AC
Adaptor. Refer to the AC POWER ADAPTOR
section for full precautions before use.
Turn off the FS3.
Plug the AC adaptor into the AC supply.
Connect the AC adaptor to Port 3.
Turn on the AC supply.
The FS3 should display Charging in
progress.
Leave the unit to recharge, for example overnight
or until it displays Charging complete.
Turn off or disconnect from the AC supply.
FS3 battery pack only.
USKY
. Make sure a H
USKY
FS3