Chapter 6. Configuring WAN Settings
6.4
Static IP
6.4.1
WAN Static IP Configuration Parameters
Table 6.3 describes the configuration parameters available for static IP connection mode.
Setting
IP Address
Subnet Mask
Gateway Address
Primary/ Secondary
DNS
6.4.2
Configuring Static IP for WAN
Follow the instructions below to configure static IP settings:
1. Select Static from the Connection Mode drop-down list as shown in Figure 6.3.
2. Enter WAN IP address in the IP Address field. This information should be provided by your ISP.
3. Enter Subnet Mask for the WAN. This information should be provided by your ISP. Typically, it is
255.255.255.0.
4. Enter gateway address provided by your ISP in the space provided.
34
Table 6.3. WAN Static IP Configuration Parameters
Description
WAN IP address provided by your ISP.
WAN subnet mask provided by your ISP. Typically, it is set as 255.255.255.0.
Gateway IP address provided by your ISP. It must be in the same subnet as
the WAN on the Internet Security Router.
You must at least enter the IP address of the primary DNS server. Secondary
DNS is optional
Figure 6.3. WAN Static IP Configuration Page
Internet Security Router User's Manual
Connection
Mode drop-
down list