Table of Contents
Advertisement
Setting Time
1
When the monitor display is open, press and
hold the SETUP button for at least 2 seconds.
The SETUP screen appears.
2
Press the Preset 2 button to activate GENERAL
setting mode. Press the Preset 2 button again to
select CLOCK ADJ., then press the TUNE button
or g DN / f UP buttons to appear the clock
adjusting menu.
3
Press the Preset 2 button to select HOUR. Then
press the g DN or f UP button to adjust
the hour.
4
Press the Preset 2 button to select MINUTE.
Then press the g DN or f UP button to
adjust the minutes.
To quickly set the time to the nearest hour, press
the Preset 2 button to select MINUTE ZERO,
then press the TUNE button or g DN / f UP
buttons.
If the minute is ":30" or under, the hour is the
current number. If the minute is more than ":30",
or if you set the minute to "00", the hour is
moved up.
To return to the previous mode, press the Preset
2 button to select RETURN, then press the
TUNE button, or the g DN or f UP button.
5
After setting is completed, press the SETUP
button to return to normal mode.
Other Useful Features
Selecting Rear Monitor
When using the optional expansion BOX (KCE-
103V), If AUX is to ON in "Setting the External
Input" (page 32), and if a rear-seat monitor is
connected to the CVA-1003E, you can switch the
picture/sound of the rear-seat monitor from the
CVA-1003E.
1
When the monitor display is open, press and
hold the SETUP button for at least 2 seconds.
The SETUP screen appears.
2
Press the Preset 3 button to activate the
AUXILIARY setting mode. Press the Preset 3
button again to select AUX OUT.
3
Press the g DN or f UP button to activate
the AUX OUT setting mode.
AUX-1 IN : The picture/sound of the device
connected to Terminal AUX 1 will be
played on the rear-seat monitor.
AUX-2 IN : The picture/sound of the device
connected to Terminal AUX 2 will be
played on the rear-seat monitor.
NAV.IN
: This function is not used with this
unit.
OFF
: mode cancels AUX OUT.
To set another setting, press the Preset 3 button
or another Preset button.
4
After setting is completed, press the SETUP
button to return to normal mode.
NOTE
If a DVD player or DVD changer is connected to the
AUX 1 or AUX 2 terminal, the DVD picture appears by
performing steps 1 and 2 of "Simultaneous Operation"
on page 35. Then, perform steps 1 to 4 on this page so
the DVD picture and sound are output.
31
-EN
Advertisement
Table of Contents
