Table of Contents
Advertisement
FE Management Port
The FE management port provides a 10/100 Mbps Ethernet connection to a
management network. The RJ-45 female connector port pin-outs are shown
in
Figure
6-4:
10/100 Mbps Ethernet
F
IGURE
The port accepts a 4- or 8-conductor Category 5 (or better) UTP Ethernet cable
with an RJ-45 male connector. A straight-through cable is required for
connection to a network port. A crossover cable is required for connection to
a management workstation.
For cables that run through plenums or air-handling spaces as described in
NEC (2002) Article 300.22(C), the cable should be suitable under NEC Article
800.50 and marked accordingly for use in plenums and air-handling spaces
with regard to smoke propagation, such as CL2-P , CL3-P , MPP or CMP . Be
sure to install cables in accordance with all applicable local regulations and
practices.
Inserting a Supervisor Card
C
AUTION
The supervisor card is hot-swappable and can be inserted into the Alcatel
Wireless LAN Switch chassis while system power is on or off.
1
Verify you understand the procedure and all precautions.
Before beginning, read the entire procedure. Verify you understand all the
precautions in these steps as well as those on
RJ-45 Female
Pin-Out
Direction
Receive
Transmit
6-4 Management Port
—This procedure should be performed by a trained technician.
1
ETH Tx+
2
ETH Tx–
3
ETH Rx+
4
5
6
ETH Rx–
7
8
page
6.
Chapter 6
The Supervisor Card
41
Advertisement
Table of Contents
