Appearance/Features; Professional Installation; Mounting - Diamond D9 & TDX TECHNOLOGY Owner's Manual

APPEARANCE/FEATURES

TDX Technology™ (Thermal Dyne eXtreme)™
Stealth Dynamic Cooling System
Thermally Optimized Aluminum Heat Sinks
0 Gauge Direct Power/Ground Terminals
10 Gauge Direct Speaker Terminals - Excepts Banana Plugs
Lowest Distortion and Noise Available in Mobile Audio
Complete Protection Circuitry
(short circuit, over current, thermal, under voltage, reverse polarity, & DC output)

PROFESSIONAL INSTALLATION

To achieve maximum performance and life time warranty coverage (see warranty
statement), Diamond Audio strongly recommends that a factory authorized Diamond
retailer professionally installs your new amplifier. The D9 amplifier is an awesome
component with category leading technology, proper attention must be taken during
installation to ensure optimum performance. The authorized Diamond retailer you
purchased your amplifier from has the training, expertise, and tools for proper
installation. If you decide to install your amplifier yourself, please read this manual
through to become familiar with the amplifiers install and set up procedures.

MOUNTING

D9 Amplifiers can be mounted in any position, even upside down, just as long as airflow
is maintained. Do not install any amplifier under carpet or behind airtight panels.
Maintain 2" of space around the amplifier so that it can breath. If mounting location has
a lack of airflow, ventilations fans must be used to circulate fresh air.
Never mount an amplifier where it can get wet, water damage is not covered by warranty.
D9 Amplifiers utilize their own stealth fan driven cooling system. A sufficient flow of air
around the amplifier will allow the TDX™ thermal management system to operate at
peak efficiency. Air is drawn into the system through center intake ducts in the heat
sink, through the fan, across the circuit board, and out through the exhaust vents on the
end panels. The TDX™ circuitry regulates when the fan is on and how fast it turns
depending on the temperature of the amplifier.
©2005 Diamond Audio Technology. All Rights Reserved
5